Assembly and instructions

Ready in minutes.

For every product you find the instructions as a PDF and the most important steps. Still stuck? Write to us on WhatsApp.

Comes pre-assembled. You need a drill – screws and plugs are included. Please check first whether your wall carries the load.

    Pull the top rim up until it clicks – done. To store it, press the rim down and the walls fold around the base. When new, the mechanism needs a little more force.

      1 open the hook · 2 unfold fully, surface facing down · 3 click the mechanism into place · 4 fold out the legs, turn it over, align the feet.

        Always place it on a level floor with the anti-slip pad supplied. If it absorbs less over time, sand the surface lightly – outdoors, please.

          No drilling, tensioned in five steps. With a real assembly video – you also reach this page through the QR code on the packaging.

          Assembled in minutes without tools. Align the spout so the water runs straight back into the sink.

            Telescopic corner caddy · step by step

            Tensioned, not drilled.

            1. Pick the rods for your ceiling heightMeasure the ceiling height, choose the combination from the table and lay the rods out from A (top) to D (bottom).
            2. Prepare the bracketsOpen the brackets (E) – the round screw heads point upwards – and slide them onto the middle rods.
            3. Connect and hang the basketsClose the brackets, join the rods and hang the baskets (F). The height can still be changed later.
            4. Set the lengthExtend rod A until the unit is 3 cm longer than the ceiling height (ceiling 297 cm → 300 cm), then tighten.
            5. Tension and checkPlace it against the ceiling at an angle, swing the bottom into the corner until it stands upright. Finally check that it holds firmly.