Assembly and instructions
Ready in minutes.
For every product you find the instructions as a PDF and the most important steps. Still stuck? Write to us on WhatsApp.
Laundry · Bestseller
Homellence Wall-Mounted Clothes Drying Rack – Retractable, 70 / 100 / 120 cm
Comes pre-assembled. You need a drill – screws and plugs are included. Please check first whether your wall carries the load.
Laundry
Homellence Collapsible Laundry Basket 42 L
Pull the top rim up until it clicks – done. To store it, press the rim down and the walls fold around the base. When new, the mechanism needs a little more force.
Laundry
Homellence Foldable Tabletop Ironing Board with 2 Covers
1 open the hook · 2 unfold fully, surface facing down · 3 click the mechanism into place · 4 fold out the legs, turn it over, align the feet.
Bathroom
Homellence Diatomite Stone Bath Mat 60 x 39 cm
Always place it on a level floor with the anti-slip pad supplied. If it absorbs less over time, sand the surface lightly – outdoors, please.
Bathroom · no drilling
Homellence Telescopic Corner Shower Caddy – No Drilling, 108–312 cm
No drilling, tensioned in five steps. With a real assembly video – you also reach this page through the QR code on the packaging.
Kitchen · new
Homellence Extendable Dish Drying Rack – Stainless Steel, Wide-Flex
Assembled in minutes without tools. Align the spout so the water runs straight back into the sink.
Telescopic corner caddy · step by step
Tensioned, not drilled.
- Pick the rods for your ceiling heightMeasure the ceiling height, choose the combination from the table and lay the rods out from A (top) to D (bottom).
- Prepare the bracketsOpen the brackets (E) – the round screw heads point upwards – and slide them onto the middle rods.
- Connect and hang the basketsClose the brackets, join the rods and hang the baskets (F). The height can still be changed later.
- Set the lengthExtend rod A until the unit is 3 cm longer than the ceiling height (ceiling 297 cm → 300 cm), then tighten.
- Tension and checkPlace it against the ceiling at an angle, swing the bottom into the corner until it stands upright. Finally check that it holds firmly.